Introduction of synthetic rubber adhesive
GOOD’s synthetic rubber adhesive is a powerful, heat-resistant, aging-resistant, saving, high solids super glue, good for decorative plate cover sheeting, fireproofing board, plastic, wood, floor, carpet, all purposed adhesive, solvent adhesive, super resin, super chloroprene adhesive.
Application of synthetic rubber adhesive
Widely used for the bonding of aluminum-plastic composite board, fireproofing board, plastics, wood, fabrics, floor, carpet, ceramics and etc. in the fields of plate-type furniture, kitchen furniture and internal decoration. Good for plank lamination and floor lamination.
yellow viscous liquid
Tack retention time
Directions for Use
1.Surface Preparation: Surfaces must be clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.
2.Application Temperature: For best results the temperature of the adhesive and the surfaces being bonded should be at least 50°F (10°C).
①Put proper quantity of adhesive on the materials surface;
②Brush on both surfaces;
③Evenly brush the adhesive on the surface with a toothed brush. It should be brushed no more than once to avoid bubbles in the glue layer in the same direction.
④Leave it for 5-15 minutes after brushing, it can be used for bonding when the adhesive layer is dry
⑤Uniform fully operate, mastering the best position, paste by one time. Gradually bonding from one side to the other.
⑥Bonding with appropriate pressure, squeeze the air bubble, dense the layer, improve the quality of bonding by using the rubber hammer.
Packing of Synthetic Rubber Adhesive
Packed in iron tin or drum